Sliding Bar Ball, Installing
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Camshaft Spacer: T40191
- : T40191/1
- Protective Eyewear
Installing
CAUTION:
Risk of injuring the eyes due to the sliding bar ball springing out.
- Wear protective eyewear.
-- Insert the spring -1- in the camshaft.
-- Place the ball -2- on the spring in the camshaft.
-- Push the ball and spring downward in direction of -arrow A- using the : T40191/1 and hold.
-- Push the sliding bar -3- in direction of -arrow B-.