Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING: Removing

Depending on the model, preliminary work may be required. Refer to Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING .

-- Remove the Throttle Valve Control Module -J338-. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .

-- Remove the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- Lift the clamp -1 and 3-, and remove the coolant hoses.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -arrow- for the Engine Temperature Control Actuator -N493-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 to 5-.

Fig 1: Engine Temperature Control Actuator Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Take the Engine Temperature Control Actuator -N493- off the centering pins and remove it from the engine oil cooler.