Input Shaft Seal, Replacing

Special tools and workshop equipment required 

• Bearing/Bushing Installer - Multiple Use: VW295 
• Bearing Installer - Wheel Bearing: 3144 
• Plate: T40285 

Procedure 

-- Remove the operating head. Refer to OPERATING HEAD, REMOVING AND INSTALLING .

-- Place the operating head with the front side upward on the : T40285  as shown in the illustration.

Fig 1: Removing Seal From Drive Head

Courtesy of AUDI OF AMERICA, LLC

-- Drive out the seal from the operating head using the : VW295  .

-- Place the operating head with the front side downward on the workbench.

Courtesy of AUDI OF AMERICA, LLC

-- Drive in the gasket with the : 3144  .

• Installation position: the open side of the gasket points to the tool.

-- Install the operating head. Refer to OPERATING HEAD, REMOVING AND INSTALLING .