Dual Clutch, Removing And Installing: Installing: Notes

NOTE:

The double shaft seal for the input shaft must always be replaced! Refer to INPUT SHAFT SEAL, REPLACING .

-- Check if the sleeves -1 and 2- are installed.

Courtesy of AUDI OF AMERICA, LLC

-- Coat the new seals -3, 4 and 5- with ATF and install.

-- Insert the seal -6-.

NOTE:

Make sure no dirt can fall into the transmission while cleaning.

-- Install the engaging bearing with the slave cylinder and tighten the three bolts -arrows- evenly.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Depending on the version the three bolts -arrows- may not be present.

NOTE:

Pay attention that the engaging bearing is installed correctly to the slave cylinder.

The ball bearings are visible! -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Install the :T40288 in the threaded hole approximately 120° offset.

Courtesy of AUDI OF AMERICA, LLC