LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2019 >> A4 Titanium >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Turbocharger, Supercharger [CVKB,DBPA,CWNA,CVLA,DEMA,DHDA] >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Pressure Sensor -G31-, Removing And Installing >> Installing

Charge Air Pressure Sensor -G31-, Removing And Installing: Installing

Install in reverse order of removal and Note The Following: 

-- Bring the Charge Air Pressure Sensor -G31- into the installation position and turn clockwise until it engages.

NOTE:

Replace the O-ring after removing.

If the catch on the air duct pipe is broken secure the Charge Air Pressure Sensor -G31- with two bolts. Refer to Parts Information.

scientia non olet · About LEMON Manuals