Transmission Output Shaft Ball Bearing, Replacing

Special Tools And Workshop Equipment Required

-- Remove the center differential housing. Refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING .

-- Remove the locking ring -A- on the transmission output shaft with splines and the ball bearing circlip -B-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the transmission output shaft from the center differential housing using the :VW409 .

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the seal.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To protect the housing lay for example an extractor lever -A- underneath.

-- Remove the transmission output shaft ball bearing with splines.

Courtesy of AUDI OF AMERICA, LLC

-- Install the transmission output shaft ball bearing with splines.

Courtesy of AUDI OF AMERICA, LLC

-- Install the ball bearing circlip -B-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -item A-.

-- Install the transmission output shaft into the center differential housing using the :VW412 .

Courtesy of AUDI OF AMERICA, LLC

-- Install the locking ring -arrow- into the groove in the transmission output shaft.

Courtesy of AUDI OF AMERICA, LLC

-- Install the center differential housing. Refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING .

-- Install the seal for the transmission output shaft with splines. Refer to TRANSMISSION OUTPUT SHAFT SEAL, REPLACING .

-- Fill the transmission fluid and check the fluid level. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .