Cylinder Head Cover - Tightening Specifications And Sequence

Fig 1: Cylinder Head Cover Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

Pay attention that the cylinder head cover is not tilted.

-- Tighten the bolts in the steps shown in the sequence:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 to 6-	Install all the way in multiple steps by hand
2.	-1 to 6-	8 Nm
3.	-1 to 6-	90° additional turn