Stabilizer Bar, Removing And Installing, Multi-Link Suspension Vehicles With Front Wheel Drive: Notes
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm: VAG1331
- Torque Wrench 1331 Insert - Ring Wrench - 16mm: VAG1331/12
NOTE:
When loosening or tightening the nut to secure the coupling rod to the stabilizer bar, counterhold on the respective coupling rod stud to prevent it from rotating.
The counter hold tool cannot be tilted.
The following work steps are described for the left side of the vehicle. These work steps also apply simultaneously for right side of vehicle.