Outer CV Joint with Bolt, Installing

Fig 1: Apply Grease

Courtesy of AUDI OF AMERICA, LLC

-- Before installing joint piece, splines -arrow A- must be lightly coated with grease used in joint.

-- Install old drive shaft bolt in joint as shown in the illustration.

Fig 2: Drive Joint Onto Shaft With Plastic Hammer Until Circlip Engages

Courtesy of AUDI OF AMERICA, LLC

-- Drive joint onto shaft with plastic hammer until circlip engages.

Installed Location of Spring Washer on Inner Joint. 

Fig 3: Identifying Dished Washer

Courtesy of AUDI OF AMERICA, LLC