Lower Transverse Link, Removing And Installing: Installing

Install in reverse order of removal while noting the following:

• Note the applied marking of the eccentric screw -B- to the subframe.
• The transverse link threaded connection may only be fastened if the dimension between the wheel hub center and the lower edge of the wheel housing that was measured before assembly is reached. Refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .

If on vehicles with electronic damping (Audi magnetic ride) the coupling rod of a sensor for the level control system is loosened, then the sensor for the level control system is removed and installed or replaced:

• "Re-adapt control position". Refer to Vehicle Diagnostic Tester.
• On vehicles with lane assistance calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
• Evaluate the need for a basic setting of the headlamps. Refer to HEADLAMP, ADJUSTING .

-- Overview table for when an axle alignment is needed. Refer to EVALUATING NEED FOR AXLE ALIGNMENT .