Axle Beam Bonded Rubber Bushing, Replacing: Installing
-- Pay attention to the installed location of the bonded rubber bushing -1- on the axle beam -2-.
The tab -arrow A- of the bonded rubber bushing -1- must point to the notch -arrow B- in the axle bearing -2-.
-- Mount the special tools as illustrated.
1 - : T10254/5
2 - : T10254/4
3 - : VAS6178 with : T10205/13
4 - : T10495/1
5 - Bonded Rubber Bushing
6 - : T10495/3
7 - : T10254/4
-- Before installing bonded rubber bushing, make sure that the mark on the bonded rubber bushing aligns with the mark on the axle beam.
-- Press in the bonded rubber mount to the stop.
-- Check the installed position of the bonded rubber bushing.
Further installation is performed in reverse order of removal, while noting the following:
On vehicles with level control system sensor if the coupling rod from the level control system sensor was removed of a level control system sensor was remove and reinstalled or replaced:
- "Re-adapt control position". Refer to Vehicle Diagnostic Tester.
- On vehicles with lane assistance calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
- Evaluate the need for a basic setting of the headlamps. Refer to HEADLAMP, ADJUSTING .
-- Perform an axle alignment. Refer to VEHICLE ALIGNMENT .