Overview - Front Three-Point Seat Belt
Courtesy of AUDI OF AMERICA, LLC
- Stop Sleeves
- Permanent, welded with the lock washer on the bolt
- Lock Washer
- Permanent, pushed on the bolt threads
- Bolt
- 40 Nm
- Replace the bolt if it was removed because of an accident when the seat belt was buckled.
- Connector
- Driver side: for Driver Seat Belt Tensioner Igniter 1 -N153-
- Front passenger side: for Front Passenger Seat Belt Tensioner Igniter 1 -N154-
- Automatic Belt Retractor
- Driver side: with Driver Seat Belt Tensioner Igniter 1 -N153- and market-specific version with Driver Belt Force Limiter -G551-
- Front passenger side: with Front Passenger Seat Belt Tensioner Igniter 1 -N154- and market-specific version with Front Passenger Belt Force Limiter -G552-
- Removing and Installing. Refer to FRONT THREE-POINT SEAT BELT, REMOVING AND INSTALLING .
- Seat Belt Guide
- Must swing in carrier direction after tightening bolt
- Bolt
- 40 Nm
- Replace the bolt if it was removed because of an accident when the seat belt was buckled.
- Connector
- Driver side: for Driver Seat Belt Tensioner Igniter 1 -N153-
- Front passenger side: for Front Passenger Seat Belt Tensioner Igniter 1 -N154-
- Pop Rivet Nut
- Bolt
- Connector
- Driver side: for Left Front Seat Belt Tensioner Control Module -J854-
- Front passenger side: for Right Front Seat Belt Tensioner Control Module -J855-
- Automatic Belt Retractor
- Driver side: with Driver Seat Belt Tensioner Igniter 1 -N153-, Left Front Seat Belt Tensioner Control Module -J854- and market-specific version with Driver Belt Force Limiter -G551-
- Front passenger side: with Front Passenger Seat Belt Tensioner Igniter 1 -N154-, Right Front Seat Belt Tensioner Control Module -J855- and market-specific version with Front Passenger Belt Force Limiter -G552-
- Removing and Installing. Refer to FRONT THREE-POINT SEAT BELT, REMOVING AND INSTALLING .
- After replacing the Left Front Seat Belt Tensioner Control Module -J854- / Right Front Seat Belt Tensioner Control Module -J855-, the control module must be coded using the Vehicle Diagnostic Tester.
- Lock Washer
- Permanent, pushed on the bolt threads
- Bolt
- 40 Nm
- Permanent, secured with the lock washer on the belt end fitting
- Replace the bolt if it was removed because of an accident when the seat belt was buckled.
- Belt End Fitting
- Bolt
- 20 Nm
- Permanent, secured with the lock washer on the belt end fitting
- Replace the bolt if it was removed because of an accident when the seat belt was buckled.