Airbag Connector, Replacing: Installing

Fig 1: Release Connector Lock Using A Small Screwdriver & Disconnect Harness Connector

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
To prevent electrostatic charge, the technician must not leave the vehicle during the procedure.

-- Connect the connector -1- to the airbag igniter -arrow A-.

-- Press in the connector lock -2- -arrow B-. While doing this, the connector is pushed into the airbag igniter and locks into place.

Further installation is performed in reverse order of removal, while noting the following:

NOTE:

Make sure the connectors are installed all the way and engage audibly.