Fresh Air Blower -V2-, Removing And Installing: Removing
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- Release the quick-release (screw or clip) -1- with a screwdriver (or with pliers).
NOTE:
There are different versions for securing the cover -2- (bolts or clip -1-). To replace the clip version, if applicable. Refer to the Parts Information.
Pry the clip version out, for example, with pliers or a screwdriver.
-- Remove the cover -2-.
-- Disconnect the connector -3-.
-- Remove the bolt -2-, if equipped.
-- Lift the securing tab -4- and turn the fresh air blower -1- clockwise in direction of -arrow-.
-- Remove the fresh air blower from the evaporator housing lower section.
CAUTION:
Fan wheel imbalance.
- Do not grasp fan wheel of the Fresh Air Blower -V2-, force against the fan wheel or shifting the balancing weights fastened to fan wheel may cause imbalance and then problems during operation.