Air Distribution Housing, Removing And Installing: Removing

-- Remove the heater and A/C unit. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING .

-- Remove the coolant pipes from the heater core. Refer to HEATER CORE, REMOVING AND INSTALLING .

-- Disconnect the connector from the fresh/recirculated air door motor and free up the wiring harness.

-- Remove the screws -2-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

There are currently five screws -2- (three at the top and two at the bottom).

-- Release the tabs -1 and 3-.

-- Tilt the air distribution housing -4- toward the rear in direction of -arrow- and disengage.