Refrigerant Lines, Disconnecting And Connecting At Condenser, A3: Removing
-- Discharge the refrigerant circuit. Refer to Refrigerant Circuit (Refrigerant R134a Servicing, Refrigerant Circuit, Working with A/C Service Station) or Working with A/C Service Station (1 Of 2) / Working with A/C Service Station (2 Of 2) .
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Open the tab -1- in direction of -arrow- and remove the cover.
Depending on the model can the version of the cover -2- can be different or the cover is not present.
Refrigerant lines from condenser to the inner heat exchanger and to the A/C compressor is available in different versions, depending on version of vehicle. Refer to the Parts Information. One vehicles with a 2.5L TFSI engine (Audi RS3) in the refrigerant lines -1 and 3- additional connection locations -2 and 4- are installed. If necessary disconnect the refrigerant lines at these connection locations -2 and 4-. For bolts on the connection locations -2 and 4- the same tightening specifications apply as for the bolts on the refrigerant lines on the inner heat exchanger or on the condenser.
On vehicle with a 2.5L TFSI engine (Audi RS3) different versions of the refrigerant line from the condenser -1 and 3- can only be removed if necessary with the condenser removed, if necessary disconnect the refrigerant lines from the connection locations on the refrigerant lines -2 and 4-.
Danger due to refrigerant coming out under pressure.
Danger of frost bite to skin and other parts of the body.
- Evacuate the refrigerant and immediately open the refrigerant circuit afterward.
- If more than 10 minutes have elapsed since evacuating the refrigerant and the refrigerant circuit was not opened, evacuate the refrigerant again. Pressure in the refrigerant circuit is caused by evaporation.
-- Remove the bolts -2 and 3- and remove the refrigerant lines -1 and 4-.
This illustration show a refrigerant line without the connection for a A/C Pressure/Temperature Sensor -G395-. An A/C Pressure/Temperature Sensor -G395- is installed on specific vehicles without a high-voltage system. Refer to A/C Pressure/Temperature Sensor -G395-, REMOVING AND INSTALLING .
Disconnect the connector to the sensor on a vehicle with a A/C Pressure/Temperature Sensor -G395-. Refer to A/C Pressure/Temperature Sensor -G395-, REMOVING AND INSTALLING .
-- Seal the open lines and connections with clean plugs from the Engine Bung Set :VAS6122 .