A/C Pressure/Temperature Sensor -G395-, Removing And Installing: Installing

Install in reverse order of removal and note the following:

Check the connection -4- for contamination or damage if necessary clean or replace the refrigerant line.
Tightening specification. Refer to OVERVIEW - CONDENSER, A/C COMPRESSOR, REFRIGERANT LINES AND EXPANSION VALVE (electrically-driven A/C compressor, refrigerant lines, high-voltage battery heat exchanger).

NOTE:

Replace the O-ring seal -3-. Refer to REFRIGERANT CIRCUIT SEALS . Allocation. Refer to the Parts Information.

At the start of production, the A/C Pressure/Temperature Sensor -G395- is only received together with the refrigerant line. If this is the case, replace the refrigerant line with the A/C Pressure/Temperature Sensor -G395- if necessary. Refer to Parts Information.

-- Evacuate and charge the refrigerant circuit. Refer to Refrigerant Circuit (Refrigerant R134a Servicing, Refrigerant Circuit, Working with A/C Service Station) or Working with A/C Service Station (1 Of 2) / Working with A/C Service Station (2 Of 2) .

-- Operate the A/C system after charging the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

-- Check the DTC memory and erase any displayed entries using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.