Overview - Front Backrest, Backrest Adjustment Motor
WARNING: This page is about a different variant/trim than selected.
NOTE:
The cushion and cover are not shown in the illustration.
- Adjustment Shaft
- The threaded hole for the nut -8- must be cleaned, for example, with a thread tap.
- Coat the threads on the adjustment shaft with locking fluid before installing the nut. Refer to the Parts Information.
- Driver Backrest Adjustment Motor -V45-
- Front passenger side: Front Passenger Backrest Adjustment Motor -V46-
- Removing and Installing. Refer to Driver Backrest Adjustment Motor -V45- /Front Passenger Backrest Adjustment Motor -V46-, REMOVING AND INSTALLING .
- Rivet
- Quantity: 2
- Bracket
- Bolt
- 7.5 Nm
- Replace after removing.
- Clean the threaded hole for the bolt with a thread tap, for example
- Use locking fluid when installing the bolt. Refer to the Parts Information for the locking fluid.
- Backrest Frame
- Washer
- Nut
- 8 Nm
- Replace after removing.