Overview - Electric Vacuum Pump, 1.5L TFSI Engine, G-Tron

WARNING: This page is about a different variant/trim than selected.

NOTE:

Clean the bolts and nuts before reusing.

Always replace self-locking nuts and bolts.

Always replace damaged nuts and bolts.

Fig 1: Exploded View Of Electric Vacuum Pump

Courtesy of AUDI OF AMERICA, LLC

Brake System Vacuum Pump -V192-
- Component location. Refer to Fig 2.
- Do not disassemble
- Check in "Guided Fault Finding" using the Vehicle Diagnostic Tester.
Vacuum Line
Vacuum Sensor -G608-
- Allocation. Refer to the Parts Information.
- Refer to Vacuum Sensor -G608-, REMOVING AND INSTALLING
Check Valve
Locking Plate
Heat Shield
Bolt
- 2.5 Nm
Bolt
- 20 Nm
Nut
- 7 Nm
Bracket
Connector
Bracket
Vacuum Hose

Component Location - Brake System Vacuum Pump V192

Fig 2: Component Location - Brake System Vacuum Pump -V192-

Courtesy of AUDI OF AMERICA, LLC