Overview - Electric Vacuum Pump, 1.0L TFSI Engine
WARNING: This page is about a different variant/trim than selected.
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.
- Bracket
- Secured to the engine mount
- Brake System Vacuum Pump -V192-
- Component location: in the front right side of the engine compartment
- Do not disassemble
- Check in "Guided Fault Finding" using the Vehicle Diagnostic Tester.
- Refer to ELECTRIC VACUUM PUMP, REMOVING AND INSTALLING, 1.0L TFSI ENGINE
- Bracket
- Rubber Bushing
- Check for proper seating
- Installation position: the washer points downward
- Bolt
- 8 Nm
- Bolt
- 8 Nm