Electric Vacuum Pump, Removing And Installing, 1.5L TFSI Engine, G-Tron: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Remove the center underbody trim panel. Refer to UNDERBODY TRIM PANELS, REMOVING AND INSTALLING .
-- If necessary, remove the right drive axle heat shield. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .
-- Remove the bolts -3- and remove the heat shield -2- from the Brake System Vacuum Pump -V192- -1-.
-- Disconnect the connector -3-.
-- Disconnect the vacuum hose -4-.
-- Open the retainer -arrow- and remove the vacuum line.
-- Remove the screws -2-, and remove the bracket with the Brake System Vacuum Pump -V192- -1-.
-- If necessary, disconnect the vacuum pump from the bracket.