Brake Pads, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Torque Wrench 1331 5-50Nm: VAG1331
- Tool Holder : VAS6564/2 from Brake Bleeding Tool Set: VAS6564
- Torque Wrench 1331 Insert - Ratchet Head: VAS6784
- Piston Resetting Tool: T10145
- Hex Bit - 7mm: T10503
- Lithium Grease: G 052 150 A2 . Refer to the Parts Information.
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.
Installation position of the brake caliper on a torsion beam axle A : A :
1 - Brake Caliper
Installation Position of Multi-Link Suspension B :
1 - Brake Caliper