Overview - Brake Pedal

WARNING: This page is about a different variant/trim than selected.

NOTE:

Clean the bolts and nuts before reusing.

Always replace self-locking nuts and bolts.

Always replace damaged nuts and bolts.

WARNING:

Risk of accident!

Fig 1: Exploded View Of Brake Pedal

Courtesy of AUDI OF AMERICA, LLC

Brake Pedal
- Refer to BRAKE PEDAL, REMOVING AND INSTALLING
- Refer to BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER
- Refer to BRAKE PEDAL, ATTACHING TO BRAKE BOOSTER
Bearing Shell
- Installed between the brake booster mount and the brake pedal
Mount
- For the brake booster ball head
Bearing Bushing
- Cannot be replaced
- Note the installation position
Bushing
- Oval
Clip
- Replace after removing.
- For mounting pin
Bushing
- Oval
Nuts
- Replace after removing.
- Self-locking
- Refer to Fig 2
Bushings
- Round
Pedal Assembly/Mounting Bracket
- Refer to MOUNTING BRACKET, REMOVING AND INSTALLING
Mounting Pin
- Remove the mounting bracket to remove.
- Cannot be removed without being damaged
  CAUTION:
  Do not lubricate or grease the mounting pin. The mounting pin must remain dry.
Pedal Rubber

Mounting Bracket - Tightening Specification and Sequence

Fig 2: Brake Booster - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nuts to 25 Nm in the sequence -1 through 4-.