Front Shock Absorbers, Venting

Special tools and workshop equipment required 

• Hand drill
• 3 mm thread tap
• 6 mm thread tap
• Oil collecting container
• Protective eyewear

Procedure 

Fig 1: Audi Magnetic Ride Front Shock Absorber

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Clamp magnetic ride shock absorber vertically in vise.

-- Drill a 3 mm hole -arrow A- through the shock absorber outer tube.

-- Drill a second 6 mm diameter hole -arrow B- through the shock absorber outer tube.

-- Hold shock absorber over appropriate container for catching oil and move piston rod repeatedly through entire stroke until no more oil flows out.