Drive Axle With Triple Roller Joint AAR2600I/AAR3300I, Mounted On Transmission Stub Shaft
WARNING: This page is about a different variant/trim than selected.
Filling Joints with Grease
| Grease - Refer to the Parts Information | Outer Joint | Inner Joint/Triple Roller Joint |
|---|---|---|
| Total quantity | 120 g | 140 g |
| In joint | 80 g | 70 g |
| In protective joint boot | 40 g | 70 g |
- Outer CV Joint
- Replace only as complete unit
- Removing. Refer to DRIVE AXLE WITH TRIPLE ROLLER JOINT AAR2600I/AAR3300I, SERVICING, MOUNTED ON TRANSMISSION STUB SHAFT - Removing the Outer CV Joint
- Installing: Drive onto shaft with plastic mallet until the compressed circlip seats
- Checking. Refer to OUTER CV JOINT, CHECKING .
- Bolt
- : WHT.005.437 / black = 200 Nm +180° additional turn
- : WHT.005.437.A / silver = 200 Nm + 90° additional turn
- Always replace if removed
- Loosening and tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
- Before installing, clean the threads in the CV joint with a thread tap.
- Locking Ring
- Always replace if removed
- Insert in shaft groove
- Clamp
- Tensioning. Refer to Figure
- Always replace if removed
- CV Boot
- Check for tears and scuffing
- Clamp
- Tensioning. Refer to Figure
- Always replace if removed
- Drive Axle
- Clamp
- Tensioning. Refer to Figure
- Always replace if removed
- CV Boot for Triple Roller Joint
- Check for tears and scuffing
- Clamp
- Tensioning. Refer to Figure
- Always replace if removed
- Triple Roller Star with Rollers
The chamfer -arrow- faces the drive axle splines
- Locking Ring
- Always replace if removed
- Insert in shaft groove
- Adapter
- Joint
- Cap