Right Drive Axle Bolted Inner Joint: Installing

Install in reverse order of removal while noting the following:

• Lightly coat the splines on the outer joint with assembly paste before installing the outer joint into the wheel hub. Refer to the Vehicle Diagnostic Tester.

On vehicles with level control system sensor if the coupling rod from the level control system sensor was removed of a level control system sensor was remove and reinstalled or replaced:

• "Re-adapt control position". Refer to Vehicle Diagnostic Tester.
• On vehicles with lane assistance calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
• Evaluate the need for a basic setting of the headlamps. Refer to HEADLAMP, ADJUSTING .