Rear Door Window, Removing And Installing

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Door Window, Removing

Fig 1: Removing Door Window With Standard Glass

Courtesy of AUDI OF AMERICA, LLC

-- Remove the inner window shaft strip. Refer to INNER WINDOW SHAFT STRIP, REMOVING AND INSTALLING .

-- Remove the door inner cover. Refer to DOOR INNER COVER, REMOVING AND INSTALLING .

-- Insert the : T40231 on both side of the door window and push it downward on the mount on the window regulator -1-.

-- The mount on the window regulator bends far enough so that the door window can be lifted upward with the mounting pin.

-- Remove the door window -2- upward from the mount and remove it from the door.

Door Window, Installing

Fig 2: Installing Door Window

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The mounting pins must be pushed in first with new door windows.

-- Install the mounting pins -2- in the center of the door window -1- and push the clamping pin in so that it is flush.

-- Insert the door window -1- at an angle toward the rear in door window guide.

Fig 3: Inserting Door Window

Courtesy of AUDI OF AMERICA, LLC

-- Line up the door window inside the window guides and push it down. Make sure the door window moves exactly into the front and rear mount.

-- Press the window glass down into window regulator mount.

-- The mounting pins will audibly lock into the mount.