Front Level Control System Sensor -G78- / -G289-, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Installation is the reverse of removal, with special attention to the following:

NOTE:

The level control system sensor lever must point toward vehicle exterior.

The thread on the level control system sensor must be installed in the front hole in the control arm. The tab on the level control system sensor must fit into the rear hole to assure that the installation position is correct.

On vehicles with level control system sensor if the coupling rod from the level control system sensor was removed of a level control system sensor was remove and reinstalled or replaced:

"Re-adapt control position". Refer to Vehicle Diagnostic Tester.
On vehicles with lane assistance calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
Evaluate the need for a basic setting of the headlamps. Refer to HEADLAMP, ADJUSTING .