Outer Rear Three-Point Seat Belt, Removing And Installing, Sedan: Installing

Fig 1: Disengage & Remove Automatic Belt Retractor

Courtesy of AUDI OF AMERICA, LLC

-- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.

-- Insert the three-point seat belt with the anti-twist mechanism and bolt -2- into the mount -3-.

-- Push the three-point seat belt -1- all the way forward -arrow- and tighten the bolt at the same time.

-- Vehicle versions with belt tensioner: place the connector -1- on the igniter in direction of -arrow A- and push in the connector lock -2- in direction of -arrow B-. While doing this, the connector is pushed into the igniter and locks into place.

Fig 2: Release Connector Lock Using A Small Screwdriver & Disconnect Harness Connector

Courtesy of AUDI OF AMERICA, LLC

• The securing tabs -arrow- on the carpet must contact the opening on the belt tensioner -2-.

  Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolt -1- on the belt tensioner.

Further installation is the reverse order of removal.