Overview - Pedestrian Protection, Vehicles With 3 Sensors Through My 2016

WARNING: This page is about a different variant/trim than selected.

Fig 1: Pedestrian Protection Vehicles With 3 Sensors Exploded View

Courtesy of AUDI OF AMERICA, LLC

Pedestrian Protection Center Crash Sensor -G693-
- Installation location: in the center of the vehicle on the bumper cover.
- Removing and Installing. Refer to Pedestrian Protection Center Crash Sensor -G693-, REMOVING AND INSTALLING .
Bolt
- 6 Nm
Bolt
- 6 Nm
Front Passenger Side Pedestrian Protection Crash Sensor -G571-
- Installation location: on the bumper cover
- Removing and Installing. Refer to PEDESTRIAN PROTECTION CRASH SENSOR -G570- / -G571-, REMOVING AND INSTALLING .
Nut/Clip
- 8 Nm
- Depending on the version: either 2 nuts or nut and clip
Pedestrian Protection Trigger 2 -G599-
- Triggered Pedestrian Protection, Resetting. Refer to HINGE, RESETTING
- Removing and Installing. Refer to PEDESTRIAN PROTECTION TRIGGER 1 -G598- / PEDESTRIAN PROTECTION TRIGGER 2 -G599-, REMOVING AND INSTALLING .
Pedestrian Protection Trigger 1 -G598-
- Triggered Pedestrian Protection, Resetting. Refer to HINGE, RESETTING
- Removing and Installing. Refer to PEDESTRIAN PROTECTION TRIGGER 1 -G598- / PEDESTRIAN PROTECTION TRIGGER 2 -G599-, REMOVING AND INSTALLING .
Nut/Clip
- 8 Nm
- Depending on the version: either 2 nuts or nut and clip
Driver Side Pedestrian Protection Crash Sensor -G570-
- Installation location: on the bumper cover
- Removing and Installing. Refer to PEDESTRIAN PROTECTION CRASH SENSOR -G570- / -G571-, REMOVING AND INSTALLING .
Bolt
- 6 Nm