Overview - Pedestrian Protection, Vehicles With 2 Sensors And Pressure Sensors From My 2017
WARNING: This page is about a different variant/trim than selected.
- Front Passenger Side Pedestrian Protection Crash Sensor -G571-
- Installation location: on the bumper cover
- Removing and Installing. Refer to PEDESTRIAN PROTECTION CRASH SENSOR -G570- / -G571-, REMOVING AND INSTALLING .
- Bolt
- 6 Nm
- Pedestrian Protection Trigger 2 -G599-
- Triggered Pedestrian Protection, Resetting. Refer to HINGE, RESETTING
- Removing and Installing. Refer to PEDESTRIAN PROTECTION TRIGGER 1 -G598- / PEDESTRIAN PROTECTION TRIGGER 2 -G599-, REMOVING AND INSTALLING .
- Seals
- Clip
- Nut
- 8 Nm
- Clip
- Seals
- Pedestrian Protection Trigger 1 -G598-
- Triggered Pedestrian Protection, Resetting. Refer to HINGE, RESETTING
- Removing and Installing. Refer to PEDESTRIAN PROTECTION TRIGGER 1 -G598- / PEDESTRIAN PROTECTION TRIGGER 2 -G599-, REMOVING AND INSTALLING .
- Bolt
- 6 Nm
- Driver Side Pedestrian Protection Crash Sensor -G570-
- Installation location: on the bumper cover
- Removing and Installing. Refer to PEDESTRIAN PROTECTION CRASH SENSOR -G570- / -G571-, REMOVING AND INSTALLING .
- Driver Side Pedestrian Protection Crash Sensor 2 -G851- /Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
- Component location: in the molded foam part on the impact member
- Unit with pressure hose; if faulty, replace with molded foam part
- Must be replaced when
- The molded foam part is visibly damaged.
- The impact member is visibly deformed.
- The bumper cover is deformed.
- The pressure hose is damaged.
- Place the pressure hose evenly into the molded foam part groove, starting from the outside and working inward
- Do not kink, pull or squeeze the pressure hose.
- Removing and Installing. Refer to DRIVER AND FRONT PASSENGER SIDE PEDESTRIAN PROTECTION CRASH SENSOR 2 -G851- AND -G852-, REMOVING AND INSTALLING, VEHICLES FROM MY 2017 .