Passenger Occupant Detection System, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

WARNING:

Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
Follow all the instructions when installing the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

Install in reverse order of removal and note the following:

NOTE:

Make sure the connectors are installed all the way and engage audibly.

When installing a new service kit, apply the basic setting for the passenger occupant detection system control module. Refer to ADDITIONAL SAFETY PRECAUTIONS - PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION, MARKET-SPECIFIC .

-- Select the "Airbag" function in "Guided Fault Finding" using the Vehicle Diagnostic Tester to complete.

-J706 Passenger Occupant Detection System Control Module, basic setting

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.