LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2019 >> A3 Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Communication) >> 91 Communication >> Radio >> Overview - Radio >> Overview - Radio, MMI Radio Most (I8D), Through My 2016

Overview - Radio, MMI Radio Most (I8D), Through My 2016

WARNING: This page is about a different variant/trim than selected.

I8D - MMI Radio MOST

Optional

GWWA91-11982Courtesy of AUDI OF AMERICA, LLC
  1. Roof Antenna -R216-
    • Not for the convertible
  2. Front Information Display Control Head -J685- in Center of the Instrument Panel
  3. Rear Window Antennas (3-door and 5-door, sedan)/Front and Rear Window Antennas Plus Antennas in the Side Trim Panels (Convertible)
  4. Information Electronics Control Module 1 -J794- in the Glove Compartment
  5. Multimedia System Control Head -E380- in the Center Console
  6. Sound Systems
  7. MOST Bus
  8. Digital Sound System Control Module -J525- under the Left Front Seat
  9. Microphone Unit in Front Roof Module -R164- (Telephone Microphone -R38-) in the Front Interior Lamp -W1-
  10. External Audio Source Connection -R199- in the Center Console Storage Compartment

The data exchange to the Bang & Olufsen sound system (9VS) occurs through the MOST bus.

The connection to other vehicle systems is established through the CAN bus (Infotainment) and the Data Bus on Board Diagnostic Interface -J533-.

Fault Finding is performed using the "Guided Fault Finding"  . Refer to Vehicle Diagnostic Tester.

Notes on MOST bus

The optical data bus "MOST bus" is used in addition to the CAN bus.

A fiber-optic cable is used as a "connecting cable". Fiber optic cables are routed inside corrugated tubes for protection.

Replace the complete fiber-optic cable if possible.

The front surface of the connectors must not be contaminated.

If disconnecting the connectors: Attach the : VAS6223/9  .

Fig 1: Fiber-Optic Conductor Repair Set VAS 6223A
GWWW00-11495Courtesy of AUDI OF AMERICA, LLC

When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink fiber optic cables.

Repairing fiber-optic cables. Refer to FIBER-OPTIC CABLES, REPAIRING .