Multimedia System Control Head -E380- IN INSTRUMENT PANEL, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

The Multimedia System Control Head -E380- can be removed when separated from the mount. The Multimedia System Control Head -E380- can be unclipped from the mount using the : 3409 .

Multimedia System Control Head -E380- Removal

-- Turn off the ignition and all electrical equipment and remove the ignition key.

-- Push the Multimedia System Control Head -E380- -1- out of the mount using the : 3409 at the left and right.

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connector from the Multimedia System Control Head -E380- -1-.

Multimedia System Control Head -E380- Mount Removal

-- Remove the vents in the center of the instrument panel. Refer to OVERVIEW - INSTRUMENT PANEL .

-- Remove the screws -2 and 3- behind the vents.

Courtesy of AUDI OF AMERICA, LLC

-- Pry the mount -1- out of the instrument panel in the direction of -arrow-.

To do this, the springs must be released using a small screwdriver through the vent openings.

CAUTION:

The surfaces can get scratched very easily. Carefully tape off all surfaces and sections!

-- Press the springs -1- with a small screw driver -2- and push out the mount upward.

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connector from the Multimedia System Control Head -E380- if still installed.