TV Antenna Amplifier 2 -R83-, REMOVING AND INSTALLING, CONVERTIBLE: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the left A-pillar trim panel. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connectors -2 and 4- from the TV Antenna Amplifier 2 -R83- -1-.
-- Only loosen the screw -3- (do not remove) and remove the TV Antenna Amplifier 2 -R83- -1- from the A-pillar.