Antenna Amplifier 2 -R111-, REMOVING AND INSTALLING, CONVERTIBLE: Removing
WARNING: This page is about a different variant/trim than selected.
-- Bring the convertible top and convertible top compartment cover into the service position as shown. Refer to the appropriate Service Information .
-- Push the convertible top compartment cover upward until it engages.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Support the convertible top with a suitable wood rod.
-- Release and disconnect the connectors -2 and 4- from the Antenna Amplifier 2 -R111- -1-.
-- Remove the screw -3- and remove the Antenna Amplifier 2 -R111- -1- from the main bearing for the convertible top on the right side.