Antenna Amplifier 2 -R111-, REMOVING AND INSTALLING, 3-DOOR AND 5-DOOR VEHICLES: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the lower rear lid trim panel. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connectors -1 and 3- from the Antenna Amplifier 2 -R111- -2-.
-- Only loosen the screw -4- (do not remove) and remove the Antenna Amplifier 2 -R111- -2- from the rear lid.