Antenna Amplifier -R24-, REMOVING AND INSTALLING, SEDAN: Removing

WARNING: This page is about a different variant/trim than selected.

-- Turn off the ignition and all electrical equipment and remove the ignition key.

-- Remove the right D-pillar trim panel. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- Release and disconnect the connectors -2 and 4- on the Antenna Amplifier -R24- -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Only loosen the screw -3- (do not remove) and remove the Antenna Amplifier -R24- -1- from the D-pillar.