Battery, Disconnecting And Connecting, Engine Compartment Battery: Connecting
WARNING: This page is about a different variant/trim than selected.
-- Market-specific: Disconnect the connector -2- from the Battery Monitoring Control Module -J367- -3-.
-- Connect the battery ground cable terminal to the battery negative pole "-" by hand and tighten the nut -1-.
-- Reconnect the connector to the Battery Monitoring Control Module -J367-.
When the battery is connected, the following steps must be performed
- Activate the one-touch up/one-touch down power window regulators. Refer to the Owner's Manual.
- Check DTC memories of all control modules and erase "Undervoltage" DTC if necessary, using the : Vehicle Diagnostic Tester .
NOTE:
After connecting the power supply, the ABS warning lamp may only go out after the vehicle has been driven a few yards.
Tightening Specifications