Overview - Adaptive Cruise Control, Version 1
WARNING: This page is about a different variant/trim than selected.
- Cover
- Distance Regulation Control Module -J428-
- Removing and installing. Refer to Distance Regulation Control Module -J428-, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Quantity: 2
- Bolt
- 5.5 Nm
- Quantity: 2
- Operating Lever for Adaptive Cruise Control
- Common part with the steering column switch module. Cannot be replaced separately
- Removing and installing. Refer to STEERING COLUMN COMBINATION SWITCH, REMOVING AND INSTALLING .
- Instrument Cluster
- With Instrument Cluster Control Module -J285-
- Impact Member
- Bracket
- Quick Release Fastener
- Always replace
- Quantity: 3
- Retaining Plate
- Removing and installing. Refer to Distance Regulation Control Module -J428- RETAINING PLATE, REMOVING AND INSTALLING, VERSION 1 .
- Stud Bolt
- Note the adjustment dimension. Refer to Installing - Measure the dimension -a- at all stud bolts using the : VAS6335 and correct if necessary.
- Quantity: 3
- Clip
- Must always be replaced if the stud bolt -Item ) OVERVIEW - ADAPTIVE CRUISE CONTROL, VERSION 1 - List Item: Stud Bolt was removed.
- Replacing. Refer to CLIP ON Distance Regulation Control Module -J428-, REPLACING, VERSION 1 .