Adaptive Cruise Control, Calibrating

Conditions

-- The distance regulation control module must be calibrated during the following conditions:

• Distance Regulation Control Module -J428- was replaced.
• Distance Regulation Control Module -J428- was removed and installed
• The front bumper was damaged.
• The rear axle toe was adjusted.
• The adjustment angle is greater than -0.8° to +0.8°.
• Too large of a vertical adjustment for the distance regulation control module (leads to a blind spot deactivation). Functional limitations emerge due to limited sensor sight, which is not the result of a dirty sensor or inclement weather conditions (for example, heavy rain/snowfall, iced over sensor, etc.).
• The DTC "no or incorrect basic setting/adaptation" is stored in the DTC memory.

For additional procedures. Refer to ADAPTIVE CRUISE CONTROL (ACC) .