Overview - Stabilizer Bar

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Stabilizer Bar

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Stabilizer Bar
- With rubber bushings
- Removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, MULTI-LINK SUSPENSION VEHICLES WITH FRONT WHEEL DRIVE .
Coupling Rod
- Removing and installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
Lower Transverse Link
Nut
- 20 Nm + 180°
- Always replace if removed
Bolt
- Always replace if removed
Bolt
- 20 Nm + 90°
- Always replace if removed
- Install evenly
Nut
- 55 Nm
- Counterhold at connecting link socket head when tightening
Subframe