Inner CV Joint, Checking: Removing

WARNING: This page is about a different variant/trim than selected.

-- Swivel the ball hub and ball cage.

-- Remove the joint in the direction of the -arrow-.

Fig 1: Direction To Press Out Ball Joint Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the balls from the cage.

-- Flip out ball hub from ball cage via running path of ball -arrows-.

Fig 2: Flip Out Ball Hub From Ball Cage Via Running Path Of Ball -Arrows-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check joint piece, ball hub, ball cage and balls for small broken off depressions (pitting build-up) and chafing.

NOTE:

Excessive backlash in joint will be noticed as a knock during load changes. Joint must be replaced in such cases. Flattening and running marks of balls are no reason to replace joint.