Headliner, Removing And Installing, A3: Removing
Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Versions Equipped with a Sliding Sunroof:
-- Open the sliding sunroof -1- all the way.
-- Open the sun shade -2- about 2 /3 .
-- To avoid dirtying the headliner, clean the : T40233 .
-- Push the : T40233 between the cover frame -2- for the sunroof opening and the headliner.
-- Release the cover frames using the : T40233 one after each other from the brackets -1- -arrows-, as shown in the illustration.
Continuation for All Vehicles:
-- Remove the front passenger seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
-- Remove the A-pillar upper trim panels. Refer to A-PILLAR UPPER TRIM PANEL, REMOVING AND INSTALLING, A3/A3 SPORTBACK, NOT A3 E-TRON .
-- Remove the B-pillar trim panels. Refer to B-PILLAR TRIM, REMOVING AND INSTALLING, A3 .
-- Remove the C-pillar trim panels. Refer to C-PILLAR TRIM, REMOVING AND INSTALLING, A3 .
-- Remove the front roof module. Refer to OVERVIEW - ROOF TRIM PANEL CONTROLS .
-- Vehicle versions with a front camera: remove the front camera trim. Refer to >>Interior Rearview Mirror with Optional Equipment: << INTERIOR REARVIEW MIRROR, REMOVING AND INSTALLING - Interior Rearview Mirror with Optional Equipment: .
-- Remove the vanity mirror light. Refer to OVERVIEW - ROOF TRIM PANEL LAMPS .
-- Remove the sun visors. Refer to SUN VISOR, REMOVING AND INSTALLING .
-- Remove the sun visor center support. Refer to SUN VISOR CENTER SUPPORT, REMOVING AND INSTALLING .
-- Remove the roof grab handle. Refer to ROOF GRAB HANDLE, REMOVING AND INSTALLING .
-- Move the steering wheel as far upward as possible using the entire adjustment range of the steering column.
-- Move the driver seat into the deepest and most forward position and position the backrest as far toward the rear as it will go.
- The headliner bends easily.
- Replace the headliner if it is bent.
-- Unclip the rear headliner at the clips -1 and 3- from the body -arrows- using the : 80-200 .
-- Unclip the rear headliner at the centering pin -2- from the body.
-- Lower the front headliner -1- and turn to the passenger door opening, to do this tip the left side downward.
-- Remove the headliner -1- through the passenger door as shown in the illustration.