Headliner, Lowering For Roof Antenna Removal
Special tools and workshop equipment required
- Pry Lever: 80-200
- Removal Wedge: T40233
- Omega Clip Tool: T40280
Removing
Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Versions Equipped with a Sliding Sunroof:
-- Open the sliding sunroof -1- all the way.
-- Open the sun shade -2- about 2 /3 .
-- To avoid getting dirt on the headliner, clean the : T40233 .
-- Push the : T40233 between the cover frame -2- for the sunroof opening and the headliner.
-- Release the cover frames using the : 80-200 one after the other from the brackets -1- in direction of -arrows- as shown in the image.
Continuation for All Vehicles:
-- Remove the upper B-pillar trim panels. Refer to B-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the C-pillar trim panels. Refer to C-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- A3 Sportback: remove the D-pillar trim panels. Refer to D-PILLAR TRIM, REMOVING AND INSTALLING, A3 SPORTBACK .
-- Remove the roof grab handle. Refer to ROOF GRAB HANDLE, REMOVING AND INSTALLING .
-- Move the front seats into the deepest and most forward position and position the backrest as far toward the front as it will go.
-- Free up the headliner in the rear lid seal area.
- The headliner bends easily.
- Replace the headliner if it is bent.
-- Unclip the back of the headliner at the clips -1 and 3- from the body -arrows- using the : 80 - 200 .
-- Unclip the rear headliner at the centering pin -2- from the body.
-- To do so, carefully guide the : 80-200 between the headliner and body.
-- Release the rear centering -arrow- in the center with the : 80-200 and lower the headliner.
-- Remove the GPS antenna. Refer to GPS ANTENNA, REMOVING AND INSTALLING .
Assembling
-- Align the headliner, press in the centering pins and clips at the back of the headliner until it engages audibly in the body mounting point.
-- Stretch over the lip of the rear lid and inner door seals.
Versions Equipped with a Sliding Sunroof:
-- Clip the sides of the headliner into the sunroof frame first, and then into the front and rear.
Further assembly is performed in reverse order.