Overview - Tail Lamps In Rear Lid, Tail Lamps With LEDS
WARNING: This page is about a different variant/trim than selected.
- Rear Lid Tail Lamp
- There are different versions. Refer to the Parts Information
- Removing and installing. Refer to REAR LID TAIL LAMP, REMOVING AND INSTALLING .
- Seal
- Replace if damaged.
- Self-adhesive
- Nut
- Tightening Specification and sequence. Refer to Fig 2
- Quantity: 3
- Back-Up Lamp Bulb
- Left Back-Up Lamp Bulb -M16-
- Right Back-Up Lamp Bulb -M17-
- 12 V, 16 W
- W16W
- Bulb, replacing. Refer to LEFT/RIGHT BACK-UP LAMP BULB -M16- / -M17-, REMOVING AND INSTALLING, TAIL LAMPS WITH LEDS, 3-DOOR VEHICLES .
- Bulb Holder
- Rear Fog Lamp Bulb
- Left Rear Fog Lamp Bulb -L46-
- Right Rear Fog Lamp Bulb -L47-
- 12 V, 21 W
- Bulb, replacing. Refer to Left Rear Fog Lamp Bulb -L46- /Right Rear Fog Lamp Bulb -L47-, REMOVING AND INSTALLING .
Rear Lid Tail Lamps, Tightening Specification and Sequence
-- Tighten the nuts -arrows- to 4 Nm in the following sequence: -A, B and C-.