Steering Column Switch Module, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Place the front wheels in a straight-ahead position - steering wheel in 0 position.
-- Adjust steering wheel downward and to rear as far as possible, use entire adjustment range of steering column adjustment for this.
-- Removing the steering wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
-- Remove the lower steering column trim. Refer to LOWER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .
WARNING:
Risk of destroying electronic components with static discharge.
- Before disconnecting connector, discharge static electricity from your body by touching an electrically grounded vehicle component such as the door latch striker pin.
-- Remove the connector lock -4-, press the release downward and disconnect the connector -3-.
-- Remove the connector lock -1- and press down and disconnect the connector -2-.
-- Remove the bolt -2-.
-- Remove the steering column switch module -1-.