Rear Parking Aid Sensor, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Outer Sensors

-- Press both tabs in direction of -arrows- to the side and press the sensor -3- inward from the outside.

Fig 1: Pressing Both Catches -Arrows - To Side And Press Sensor -3- Inward From Outside

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -2- by sliding the retainer -1- back and pressing the release down.

Inner Sensor

-- For vehicles without a trailer hitch, remove the bolts -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- For vehicles with a trailer hitch, remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Press both tabs in direction of -arrows- to the side and press the sensor -3- inward from the outside.

Fig 2: Pressing Both Catches -Arrows - To Side And Press Sensor -3- Inward From Outside

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -2- by sliding the retainer -1- back and pressing the release down.

NOTE:

If the sensor cannot be removed as described on vehicles without a trailer hitch, the rear bumper cover must be removed. Refer to BUMPER COVER, REMOVING AND INSTALLING .