LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2019 >> A3 Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Exterior Lights, Switches) >> 94 Exterior Lights, Switches >> High-Mounted Brake Lamp >> High-Mounted Brake Lamp Bulb, Removing And Installing >> High-Mounted Brake Lamp Bulb -M25-, REMOVING AND INSTALLING >> Removing

High-Mounted Brake Lamp Bulb -M25-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the spoiler. Refer to SPOILER, REMOVING AND INSTALLING .

-- Remove the bolts -3-.

GWWA94-11392Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the high-mounted brake lamp bulb -1- from the roof spoiler -2- and guide out the wiring harness through the opening.



-- Do not press brake pedal.

-- Loosen the headliner from the body near the high-mounted brake lamp. Refer to HEADLINER, REMOVING AND INSTALLING .

-- Pull the high-mounted brake lamp -2- back evenly by the cover in direction of -arrows-.

Fig 1: Disconnect Electrical Connector
GWWA94-10333Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1-.



-- Do not press brake pedal.

-- Remove the rear lid trim panel. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

GWWA94-11593Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the retainer -2- to the left in direction -arrow- and remove.

-- Open the clips -1- and remove the mount -2-.

GWWA94-11583Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the lamp -3- out of the flap -arrow-.