Headlamp Mount, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal. Note the following:

-- Insert the headlamp mount and hand-tighten the bolt.

-- Install the headlamp. Refer to HEADLAMP, REMOVING AND INSTALLING .

-- Align the headlamp -1- according to the body contour gap dimensions.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If necessary, twist the nut -2- to adjust the height.

-- Tighten the screws -3 and 4- while aligning the headlamp so that it sits flush with the out edge of the fender.

-- Check gap dimensions again, repeat adjustment of gap dimensions if necessary, as described above.

-- Adjust the headlamp. Refer to HEADLAMP, ADJUSTING .